Linear Line EN

A

Compact Rail

A

(1) Clean chips and dirt from the prepared mounting surfaces and fasten the first rail as described in the section on installation of a single rail. (2) Fasten the second rail on the ends and the center. Tighten the screws in Position A and measure the distance between the raceways of the two rails. Parallel installation of two rails

A

C R

B

Fig. 72

(3) Fasten the rail in Position B so that the distance between the raceways does not exceed the measured values in Position A while maintaining the tolerances (see pg. CR-30, tab. 22) for parallel rail installation.

B

B

Fig. 73

(4) Fasten the screw in Position C so that the distance of the raceways is as close to an average between the two values from A and B as possible. (5) Fasten all other screws and check the specified tightening torque of all fixing screws (see pg. CR-38, tab. 31).

C

C

C

Fig. 74

CR-41