Linear Line EN

5 Technical Instructions

Lubrication

Roller pin lubrication The bearings inside the rollers are lubricated for life. To reach the calcu lated service life (see pg. CR-107), a film of lubricant should always be Lubrication of the raceways Proper lubrication during normal conditions: ■ reduces friction ■ reduces wear ■ reduces the load of the contact surfaces through elastic deformations ■ reduces running noise

present between the raceway and roller, this also serves to protect against corrosion of the ground raceways.

Slider lubrication

The sliders are equipped with wiper heads that include lubricated felts which slowly release oil on the raceways for a long time. The felts inside the wiper heads can be refilled with lubrication by means of an oiling syringe with needle of OD 1.85mm (max) through the lubrication hole of the wiper located on the front side.

Lubricant

Thickening agent

Temperature range [°C]

Kinematic viscosity 40°C [mm 2 /s]

Mineral oil

Lithium soap -20... to +120 approx 110

Tab. 23

Fig. 56

The durability of the lubrication delivered by the wiper heads depends on the conditions of use. In the normal clean indoor applications, it is suggested to refill the oil every 0.5 million of cycles, 1000 km or 1 year of use whichever comes first. In different conditions, it could be necessary to refill more often, depending on the level of environment criticity. In case of severe dust and dirt conditions, it is suggested to change the entire wiper head with a new one.

When refilling the oil or the substituting the wiper heads, it is recommen ded to clean the raceways of the guide.

CR-32